*For 1-2 weeks wear, simply press down using your fingers.
*For 2-3 weeks wear, use skin-tape and simply press with
Ring-xer or pincher.
*For 4-6 weeks wear, use skin-tape and press with low heat iron.

Just simply part your hair and attach the skin extensions using the skin tape. It's simple and fast. Apply by attaching the tape backed side on your hair top and bottom (double layer).
Natural Perm Straight (NPS) texture, Yaki like straight look.

• Sold in individual pieces 

• 10.5" width and it can be cut to any size you want.

• Available 18" long. 

**Estimated amount pieces for full head (double layered): 12 pieces

Installment

1. Open up the Skin Extension and custom cut to desired width. Cut two pieces of the same width, since you will be installing them in pairs.
2. Part your hair horizontally; select a section of your hair the same width as the skin extension.
3. Take a strip of the pre-cut Skin Extension and peel the backing off. Press the Skin Extension on to the hair.
4. Lift the section up (the amount of your hair should not excide the amount on the Skin Extension) apply the second pre-cut Skin Extension directly on top of the first one. Sandwich your hair between the first and second Skin Extension.
5. Seal it with a low heat iron (this will allow you a longer wear).
6. Continue the above steps, until desired volume is accomplished.

Removal

1. Start from the lowest Point and Section the area.
2. Re-heat the Skin Extension is advised for a faster and easier removal. Spray the section with our Solvent C-22 and about 30-60 seconds.
3. Carefully each Skin Extension piece apart and slide out of the hair.
4. Use a fine comb to remove any residues left on the hair (you may apply additional remover if need it).
5. Repeat above steps, until all the Skin Extensions are removed.